Important Safety Instructions - Polaris 9300 Sport Owner's Manual

Hide thumbs Also See for 9300 Sport:
Table of Contents

Advertisement

Available languages

Available languages

Page 4

Important Safety Instructions

Section 1.
Congratulations on purchasing the Polaris 9300 Sport cleaner. Please take a moment to read through the entire manual
before installing your new robotic pool cleaner. Your cleaner must be installed and operated as specified.
READ AND FOllOW All INSTRUCTIONS
Failure to comply with the following warnings can result in permanent injury, electrocution or
drowning.
PREVENT ElECTRICAl ShOCk
To reduce risk of electrical shock:
• Connect unit to receptacle protected by a ground fault circuit interrupter (GFCI).
• Per the United States National Electric Code (NEC), keep the power unit at least five (5) feet from the edge of
the (pool/spa) water and do not remove it from its caddy. In Canada, the Canadian Electrical Code (CEC)
requires a minimum distance of 3m (10 ft.) to be maintained between the pool edge and the power unit. Never
submerge the power supply.
• Do not enter pool while the 9300 Sport is in water.
• Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge trimmers and
other equipment.
• To reduce the risk of electrical shock, do not use the 9300 Sport cleaner or power supply if the cord is worn or
damaged. Contact Zodiac Pool Systems, Inc. immediately for a replacement cord.
• Double insulation—For continued protection against possible electric shock, use only identical replacement
parts when servicing. Do not attempt repair of the 9300 Sport cleaner, power supply, power cord, or floating
cable.
• NEVER OPEN POWER SUPPLY.
• Do not use an extension cord to connect the unit to electric supply; provide a properly located outlet. The
power supply should be placed near the outlet box.
PREVENT ChIlD INJURY AND DROWNING
• To reduce the risk of injury, do not permit children to operate this product.
• Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed as part of
your pool's operational system.
Failure to comply with the following warnings could cause damage to pool equipment or
personal injury.
• The 9300 Sport must be installed and operated as specified.
• Turn the 9300 Sport off before removing it from water, and do not operate out of water.
• Do not remove the 9300 Sport from the pool for 15 minutes after the cleaning cycle has completed.
• Clean filter canister in the 9300 Sport after each use.
• Do not use the product in your pool if the water temperature is above 95˚ F (35˚ C) or below 55˚ F (13˚ C).
WARNING
CAUTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents