Polaris 9300 Sport Owner's Manual page 12

Page 12
1
Figure 27. Clean in Upright Position
2. Separate the edges of the brush and undo the tabs
as shown is Figure 28. Remove the worn brushes.
2
Figure 28. Undo the Tabs of the Brush
3. To install a new brush, position the new brush on
the roller with the spikes facing downwards. Refer
to Figure 29.
3
Figure 29. Install the New Brush
4. Thread each tab into the slot provided and gently
feed it through until the heel comes out at the
other side of the slot. Refer to Figure 30.
4
Figure 30. Pull Tabs Through Each Slot
5. Use a pair of scissors to cut the tabs 3/4 inch from
the heel so that they are no higher than the spikes
as shown in Figure 31.
6. Repeat this procedure to install the second brush.
Figure 31. Cut Tabs