Remote Control - SAGEMCOM D77T-V User Manual

33
ANSWERING MACHINE
Call filtering
When activated the filtering function allows you to monitor the
message being left by the caller as it is being recorded. You can
pick up the phone to take the call at any time.
Go to »Menu« / »Answ. Machine« / »Settings« / »Remote access«.
Press the »O O N« / »O O FF« key to activate/deactivate the Remote
access function.
To filter incoming calls you can allow callers to start recording
their message (in order to identify the caller), then pick up the
handset or press the »
If call filtering is activated, the message recorded by the caller will
be audible; if call filtering is deactivated the message will not be
audible.
The answering machine automatically interrupts recording when
you pick up the handset.
Remark : Filtering only works with handset number 1 (see the
paragraph "Screen", page 11).

Remote control

You can play back your answering machine in remote mode.
This function allows you to recover your messages and access
your answering machine from any other telephone located
outside your place of residence.
General management
When the answering machine is deactivated and remote control
is deactivated, the equipment does not answer any calls and
remote access is not possible. The base unit display is switched
off.
If the answering machine is deactivated and remote control is
active, the equipment answers a call after 10 rings by playing the
following message: "E E nter PIN".
In this mode you can remotely activate your answering machine.
Once activated the telephone is in answering machine/recording
mode, the equipment uses the operating mode already selected
by the user.
(D77V only)
« key to take the call.