Table of Contents
Advertisement
ANSWERING MACHINE
Activating/deactivating remote control
Go to »Menu« / »Answ. Machine« / »Settings« / »HS Screening«.
Select »O O n« / »O O ff« by moving the browser up
activate or deactivate remote control.
Press the »B B ACK« key to return to the previous menu.
Remote control operation
When remote control and the answering machine are both
activated, enter the PIN code when the outgoing message is
being played back in order to access the answering machine. A
long audible confirmation signal is heard telling you that the
connection has been established.
The remote interrogation code corresponds to the base unit PIN
code (see "Changing your PIN code", page 26.).
Remote control operation is described in the following section.
- If you do not press a key within 10 seconds, the machine
automatically stops.
- The code is detected during the playback of the outgoing
message.
- After three attempts at entering an incorrect PIN the telephone
terminates the session and hangs up.
- The maximum delay between two numbers is 4 seconds.
- The telephone receives commands whilst messages, memo
and the outgoing message are being read.
(D77V only)
or down
to
34
Advertisement
Table of Contents
