VAV VV550 Controller Programming and Operation
Chapter Overview
This chapter contains information about the following:
•
•
•
•
•
•
Accessing Rover/Comm5 LonTalk
Rover Overview
Rover is a service tool that allows parameters to be viewed or adjusted in the VAV VV550 Controller.
The operating and programming guide for Rover is EMTX-SVX01*-EN. Rover Comm5 is a software
application for monitoring, configuring, balancing, binding and testing VAV VV550 Controllers on
Comm 5 links.
Note: For Instructions on how to use Rover Comm5, refer to the Rover Comm5 online Help by
Laptop Requirements and Complete Connection Instructions
For instructions on connecting a PC laptop to a Comm5 link, refer to the Installing Rover Service
Tool Version 5.0, 3270 3275.
Note: A hard copy of this document is in the Rover package and an electronic copy
To connect to a Comm5 Link
1. Insert the Comm5 card in the PC laptop.
2. Connect the cables as shown in the appropriate figure. Refer
Figure 30. Connecting to a Comm5 controller through a zone sensor.
42
Accessing Rover/Comm5 LonTalk
VV550 Controller Device Home Tabs: At a Glance
Entering and Exiting the Service Mode
Overriding VAVs
Saving VAV Program
VV550 Controller Device Home Tabs: Instructions
clicking Contents and Index on the Help menu.
(Installation.pdf) can be found on the Rover installation CD-ROM.
to a Comm5 controller through a zone sensor and
controller using alligator clips.
Note: Make sure to maintain polarity.
Adapter cable
RJ11
plug
toFigure 30, p. 42
Figure 31, p. 43
for Connecting to a Comm5
Comm5
PCMCIA card
for connecting
VAV-SVP01A-EN