How To Set A New Default; How To Reset To Factory Settings - Brother MFC-795CW User Manual

Chapter 13
f
Press Auto Crop.
g
Press On.
h
If you do not want to change additional
settings, press Mono Start or
Colour Start to start scanning.
i
The number of the scanned documents
appears on the LCD.
Press OK.
j
Press d or c to preview each document
data.
Press Save All to save the data.
Note
• Auto Crop is available for paper that has
all four corners with right angles of
90 degrees. If one of the angles is not
square, Auto Crop cannot detect the
document.
• If your document is too long or wide, this
setting does not work properly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
10 mm apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use the Auto
Crop.
• The Auto Crop feature is available for up
to a maximum of 16 documents
depending on size of your documents.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
Photo Capture is blinking to avoid
damaging the card, USB Flash memory
drive or data stored on them.
106

How to set a new default

You can save the Scan to Media settings
(Quality, File Type, and Auto Crop)
you use most often by setting them as the
default settings. These settings will stay until
you change them again.
a
Press (Scan).
b
Press Scan to Media.
c
Press d or c to display
Set New Default.
d
Press Set New Default.
e
Press Yes to confirm.
f
Press Stop/Exit.
How to reset to factory
settings
You can reset the factory settings which you
set.
a
Press (Scan).
b
Press Scan to Media.
c
Press d or c to choose
Factory Reset.
d
Press Factory Reset.
e
Press Yes to confirm.
f
Press Stop/Exit.
13
13