Adjusting Sleep Mode; Using Hibernate Mode; Setting Hibernate Timeout - Lexmark XM3150 User Manual

Saving money and the environment
Use
On
Off
3
Click Submit.

Adjusting Sleep mode

1
From the home screen, navigate to:
> Settings > General Settings > Timeouts > Sleep Mode
2
In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.
3
Apply the changes.

Using Hibernate mode

Hibernate is an ultra‑low‑power operating mode.
Notes:
• Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of
the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the home screen, navigate to:
> Settings > General Settings
2
From the "Press Sleep Button" or "Press and Hold Sleep Button" menu, select Hibernate, and then touch Submit.

Setting Hibernate Timeout

Hibernate Timeout lets you set the amount of time the printer waits after a print job is processed before it goes into a
reduced power state.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
To
Reduce printer noise.
Notes:
• Print jobs are processed at a reduced speed.
•
Printer engine motors do not start until a document
is ready to print. There will be a short delay before
the first page is printed.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
205