Configuration (Standalone); Static Color Mode; Automatic Mode; Custom Static Color Mode - Chauvet SlimPAR 56 IRC IP User Manual

Configuration
(Standalone)

Static Color Mode

Automatic Mode

Custom Static
Color Mode
Master/Slave
Mode
Page 12 of 16
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To enable the Static Color Mode, do the following:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose a color (C1-C7).
4. Press <ENTER>.
To enable the Automatic Mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose your auto program (P1-P4).
4. Press <ENTER>.
You can adjust the speed of the automatic program as well.
1. Press <MENU> repeatedly until S-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to adjust the duration of each step of the automatic program
from S001 (slow) to S100 (fast).
4. Press <ENTER>.
To enable the Custom Static Color Mode:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> to choose between colors (r--, g--, b--).
3. Press <UP> or <DOWN> to choose the intensity of the color (r000-100).
4. Repeat the steps to mix additional colors to create the color you need.
5. Press <ENTER>.
The Master/Slave mode allows a single SlimPAR™ 56 IRC IP unit (the "master") to
control the actions of one or more SlimPAR™ 56 IRC IP units (the "slaves") without the
need of a DMX controller. Once set and connected, the slave units will operate in unison
with the master unit.
Slave units:
1. Press <MENU> repeatedly until 3-CH or 7-CH shows on the display. The slave unit
will operate regardless of DMX personality.
2. Press <ENTER> to accept.
3. Set the DMX address to 001.
4. Connect the DMX input of the first slave unit to the DMX output of the master unit.
5. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in Static Color Mode, Automatic or Custom Static
Color mode.
2. Make the master unit the first unit in the daisy chain.
•
Configure all the slave units before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
•
Do not connect more than 31 slave units to the master unit.
SlimPAR™ 56 IRC IP User Manual (Rev. 1)