How To Guide; How To Adjust Drum Brakes; How To Install Bearings; How To Center Handle Bars - X-TREME XB-700Li Owner's Manual

Electric bicycle/moped
Table of Contents

Advertisement

How To Adjust Drum Brakes

1.
Loosen the brake handle adjustment on handlebars to fully outward. Locate the brake cable
adjustment screw and screw this in all the way.
2.
Follow your brake cable to the brake caliper. There will be a small nut holding the metal
cable to the caliper arm. Loosen this nut, move the brake arm while holding the cable tight
until the brake just starts to drag when the tire is turned off the ground. Tighten the lock nut
back down onto the cable.
3.
Next fine tune the adjustment by screwing the cable tension screw outward to pull on brake
line until proper braking is achieved.
4.
Lock this position down by tightening the nuts.
5.
Avoid adjusting brakes on handlebars because there is a safety switch built into the handles to
kill motor while using the brakes.

How To Install Bearings

1.
Remove the rear wheel.
2.
Remove the old bearing. To do this, you will need to insert something, like a screw driver,
from the opposite side and simply push it out.
3.
Put the new bearings in. You will want to use something like a rubber mallet so you do not
crack the bearings. Set the wheel on a flat, absorbent surface, like a work bench. Tap the
bearing into the wheel evenly.
4.
Re-install the tire and test ride.

How To Center Handle Bars

1.
First remove the dash. You should not have to remove it completely, but at least split it so you
may access the space in the center of the handle bar.
2.
In the center of the handle bar you will see the head of a small bolt.
3.
Loosen this bolt up slightly until the handle bars can move to the correct position.
4.
When the bars are aligned properly tighten the bolt.
5.
Reassemble the dash pieces.

How To Align Front Forks

1.
Remove the dash on the backside.
2.
Find the 12mm bolt in the center of the handlebars and loosen it.
3.
Take a hammer and hit this bolt. Stand with the front tire between your legs. Hold the tire
with your legs and turn the handlebars into position.
4.
Tighten the 12mm bolt and reassemble the dash.
22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents