Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for X-TREME XB-420M
Summary of Contents for X-TREME XB-420M
- Page 1 X-Treme Electric Scooters XB-420M Electric Mobility Scooter Read this manual completely before riding.
- Page 2 IMPORTANT! BATTERY MAINTENANCE and CHARGING INSTRUCTIONS You MUST charge completely prior to initial use. (Follow charging instructions in your Product Handbook) Charge immediately after each use. Charge before storage. You must charge every 30 days if not in use. Charge the unit for 6-8 hours or until the light on the charger turns red &...
- Page 3 IMPORTANT PLEASE READ THIS BEFORE USING THIS PRODUCT READ THIS FIRST! WARNING This product does not conform to Federal Motor Vehicle Standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this product.
-
Page 4: Quick Reference Safety Guide
QUICK REFERENCE SAFETY GUIDE SAFETY GUIDE The recommended minimum age for riding this scooter is 16 years old. To avoid damage to the motor and footplate, do not overload the scooter. Never ride with more than one person. ... -
Page 5: Table Of Contents
DO NOT RETURN TO STORE! Do not use this vehicle for the first time until you have inflated the tires to the correct PSI and completely charged the battery. Failure to follow these instructions may damage your vehicle and void your warranty. -
Page 6: Riding Safety
Use caution! Like any sport, cycling carries the risk of injury and damage. By choosing to ride the XB-420M, you assume all responsibility for these risks. Thus, you need to know and practice the rules of safe and responsible riding. -
Page 7: Safety Basics & Operating Instructions
XB-420M, causing you to lose control. o Never carry a passenger. The maximum carrying capacity is 350 lbs. o Never ride barefoot or wearing sandals. o Don’t jump with your XB-420M. It puts great stress on everything from frame and forks to drive train. Riders... - Page 8 XB- 420M. o Never hitch a ride by holding on to another vehicle. o Never ride your XB-420M while under the influence of alcohol or other drugs. o If possible, avoid riding in bad weather, when visibility is obscured, at dusk or in the dark, or when you are very tired.
-
Page 9: Wet Weather & Night Riding
o Ride defensively. To other road users, you may be hard to see. o Concentrate on the path ahead. Avoid potholes, gravel and dirt, wet road, oil, curbs, speed bumps, drain grates and other obstacles. o Be alert for unexpected events, such as opening car doors or cars backing out of concealed driveways. - Page 10 Rules of the Road, and take the following precautions: Make sure that your XB-420M is equipped with correctly positioned and securely mounted reflectors. Make sure your clothing or cargo does not obstruct a reflector or light.
- Page 11 Release the throttle before braking. Do not “ride” the brakes. The XB-420M has a speed control dial to regulate the speed output. The rider can turn it from low to high and set it anywhere in between. On the first ride, set the knob to its slowest position until the rider feels comfortable and safe.
-
Page 12: Specifications
Store your XB-420M in a dry place. Exposing your XB- 420M to rain, snow, or other precipitation may result in damage. SPECIFICATIONS Product size (L x W x H): 64” x 28” x 40” Net Weight: 195 lbs Carrying capacity:... -
Page 13: Components
COMPONENTS 1.Battery Storage Access 4. Forward/Reverse switch (tilt seat forward) 5. Instrument panel (4 batteries total) 6. Throttle 2. Seat Recline Adjuster 7. Brake lever 3. Drop Down Arm Rests 8. Ignition Switch... - Page 14 1. Brake lever 2. High/low beam selector 3. Rearview mirror 4. Instrument Panel 5. Rearview mirror 6. Headlight switch 7. Throttle 8. Ignition switch 9. Forward/Reverse switch 10. Turn Signal 11. Speed Control Knob...
-
Page 15: Assembly And Setup
ASSEMBLY AND SETUP 1) Remove your XB-420M from its shipping carton. The XB-420M weighs about 150 lbs, so get help, and use care. Cut away any residual packing materials with a knife or scissors. Tools needed for setup are included in the XB- 420M tool kit. - Page 16 Locate the circuit breaker and switch it from off to on 8) Your XB-420M has been in transit and storage. You must charge the batteries before riding it. Charge the battery by plugging the charger into the XB-420M’s...
-
Page 17: Routine Operation
3) Verify the proper adjustment and function of the brakes. 4) Make sure the XB-420M is in good mechanical order. Visually inspect and hand-check the vehicle, and snug any loose bolts, screws, or other fasteners. - Page 18 When the brake handle is squeezed it cuts power to the accelerator. 6) Give the XB-420M some acceleration and speed by first applying the throttle gently. Try not to brake and accelerate needlessly.
-
Page 19: Battery Care And Maintenance
Battery Care and Maintenance What to Expect of Your Batteries, Ideally The battery is a sealed lead-acid type, with a gel electrolyte. With normal use, it can last for well over 300 charge/discharge cycles. Know that normal use should mean partial, and not complete discharging. - Page 20 What’s Inside Your XB-420M Battery The Battery is composed of four 12 Volt, 20 Amp-hour capacity batteries, in series, for a total capacity of 48 V, 20 Ah. The component batteries are a standard, commercially available size. Keep three things in mind, however, should you choose to service your battery.
- Page 21 When the air temperature is under 0 ºF, the battery power will decline more than one third. So it is natural that the XB-420M will not reach its normal mileage in winter or in cold weather.
-
Page 22: Battery Charging
Frequent braking and acceleration, driving into headwinds, up hills or with cargo will all cost a lot of battery energy. In these conditions, the XB-420M will not reach its normal range. Battery Charging Be sure to charge the battery completely if you will not use it for a long period. - Page 23 4) Plug the end of the charger’s cord into the socket of the adaptor first. Next connect the adaptor to the XB-420M (the charger port in located below the front of the seat). Then plug the chargers’ AC cords into the wall outlet.
- Page 24 The electric bike is powered by four 12V/20Ah batteries wired in series to provide 48 volts of potential. All batteries charge simultaneously. You should charge your XB-420M after each ride. You should charge your XB- 420M if it has not been used for 30 days or more. WARNING Do not place the battery near heat or fire.
-
Page 25: Other Maintenance
OTHER MAINTENANCE Your XB-420M should be checked once a year for a thorough inspection and adjustment. This can guarantee the comfort, safety and the normal operating life of the XB-420M. Front and Rear Brakes The adjustment of the front brake is the same as in a common motorcycle. -
Page 26: Fuse
Fuse The XB-420M comes with one 10A Glass Fuse. The fuse is located under the headlight fairing. Lubrication You should inspect and maintain your XB-420M and lubricate the mechanical power transmission components. The brake cables may also need lubrication Lubricate the brake cables with silicone or graphite lubricant. -
Page 27: Scheduled Maintenance
Scheduled Maintenance XB-420M should be checked from time to time. Refer to the maintenance schedule in the following chart: adjust ◆ change ▲ lubricate ■ Check ● Parts daily days days Bolts, nuts, screws etc-to ensure that ● ◆ ● ■... -
Page 28: Troubleshooting
TROUBLESHOOTING GUIDE Problem Cause Solution Battery gauge 1. Loose connection 1. Check the connections, does not near the power switch reconnecting any that are register or battery pack. loose. anything when 2. Battery is completely 2. Charge the battery. vehicle is on. discharged. -
Page 29: Warranty
DO NOT RETURN TO STORE! IF YOU NEED HELP CALL TOLL FREE OR GO ONLINE 1-800-772-3852 www.x-tremescooters.com/support/ For General Information or Parts Visit www.x-tremescooters.com Revised 5/17/10...