Battery Charging & Safety - X-TREME XB-700Li Owner's Manual

1．First connect to the battery charger to the charging socket located below the front of the seat or
under the front seat.
(Optionally, you can also remove the battery pack and charge outside of the bike if preferred)
2. Insert the power plug on the battery charger into power outlet
3.
While charging, the light on the battery charger will illuminate Red.
4. When fully charged, the light will illuminate Green.
5. NEVER CHARGE FOR OVER 8 HOURS. DAMAGE MAY OCCUR TO BATTERY
6. Always charge the bike in an enclosed area outdoors away from weather & wet conditions.
7. Ensure charge input voltage on charger is set to 110vac - added
NEVER CHARGE THE BIKE INSIDE YOUR HOME
ONLY CONNECT THE BATTERY CHARGER LEAD TO THE BIKE. NEVER
CONNECT ANY OTHER POWER SOURCE TO THE BIKE.
Battery Charging Safety Notes
1) While charging the Battery, keep the key switch OFF.
2) Verify that you are using the correct charger for your vehicle, and that the charger input
power is compatible the "house current" in your area.
3) Keep the charger and battery away from water to prevent electrical shock and shorting.
The charger is intended for indoor use only.
4) Plug the end of the charger's cord into the socket of the adaptor first. Next connect the
adaptor to the XB-700Li (the charger port in located below the front of the seat). Then
plug the chargers' AC cords into the wall outlet.
5) Read the charger label to learn about the charger indicator lights, and their meanings.
6) Generally, a short drive will require a short time to re-charge, and a long ride will require
a longer time. A complete (90%) discharge may require 6 hours to recharge. To
prevent electrolysis (battery fluid loss by hydrogen generation,) do not charge for longer
than eighteen hours.
Do not place the battery near heat or fire. Do not expose the chargers to water.
WARNING
16