Speed Dial Number Linking - Toshiba Strata DK8 User Manual

STRATA DK DIGITAL TELEPHONE
To Store a Regular Pause:
1. Press the Spd Dial Pause
button.
To Store a Long Pause:
1. Press the Spd Dial Lng
Pause button.
To Link a Number:
1. Press the Redial button.
2. Press a SD button.
. . . or . . .
Press the Speed Dial
button and enter a two-digit
Speed Dial access code.
3. Press the Speed Dial
button.
This pause—which will be one-and-a-half or three seconds, depending
on system programming—can be entered anywhere in the Speed Dial
number. The Spd Dial Pause button must be programmed as a flexible
button to allow the telephone to store pauses.
This pause, which is 10 seconds, can be entered anywhere in the Speed
Dial number.
NOTE: The Flash button will store a pause if the Spd Dial Pause button
is not programmed on a flexible button. The Flash button will store a
flash signal only if the Spd Dial Pause button is on the telephone.

SPEED DIAL NUMBER LINKING

You can link any of your personally assigned Speed Dial numbers
(1 0 ~ 4 9) to System Speed Dial codes 9 0 ~ 9 9 or to any of the optional
buttons associated with these 10 codes. Station 10 can be used to link
System Speed Dial codes 6 0 ~ 8 9 to codes 9 0 ~ 9 9. This allows up to
37 digits to be stored under one System Speed Dial button or code.
The number stored in location 9 0 ~ 9 9 will dial out first, followed by the
number linked to 9 0 ~ 99. Typically, a company's special carrier access
telephone numbers are stored in locations 9 0 ~ 9 9.
The button can be used if your telephone does not have the Speed
*
Dial button.
Station users may enter Station Speed Dial codes (1 0 ~ 4 9). Station 10
can be used to enter System Speed Dial codes 6 0 ~ 8 9.
The button can be used if your telephone does not have the Speed
*
Dial button.
FEATURE OPERATION
2-9