Manual Code Search - Radio Shack 15-309 User Manual

Manual Code Search

Manual Code Search sends codes to the device you want to control one by one at the
touch of the G button.
1. Power on the device that you want to control. For VCRs and DVD players, you must
insert a tape or disc.
2. On the universal remote, press and hold SET, then press a device key (TV, VCR/
DVD or STB). The red LED lights up and stays lit, indicating the remote is in setting
mode. Release both buttons.
n
Note: Do not hold down the keys for longer than 3 seconds or the remote enters
auto search mode.
3. Press G on the universal remote. The universal remote enters manual code search
mode and the red LED flashes.
4. Press G repeatedly on your universal remote until the device turns off. (Each press
of the G key sends a different code to your device.)
When the device turns off, the code is correct. Press the device key on your
universal remote within 10 seconds to confirm the code.
5. Press G on your universal remote to turn your device back on.
6. Verify the setup by testing various keys and functions. If some of your device's
functions do not respond to the remote, repeat steps 2-6.
8