Belt Or Brush Roll Removal And Replacement - Dirt Devil Vision Canister Owner's Manual

BELT OR BRUSH ROLL REMOVAL AND REPLACEMENT

1.
Diagram 1
Remove nozzle guard.
BELT OR BRUSH ROLL REMOVAL AND REPLACEMENT
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
1. To remove nozzle guard: turn power nozzle over and insert finger into openings near an arrow as shown (Diagram 1). Squeeze
clip and pull nozzle guard toward you.
TO REMOVE BELT:
1. Be sure belt is off motor shaft.
2. Lift and remove brush roll (Diagram 2).
3. Dispose of old belt.
TO REPLACE BELT:
1. Loop belt around motor shaft (Diagram 3).
2. Slip brush roll through belt. Place belt on raised area of brush roll without bristles.
3. Pull brush towards you and insert into side holder #1 and then #2 (Diagram 4).
4. Replace nozzle guard. Match the front tabs to the slots on the nozzle base. Swing down to snap hooks. Press firmly on entir
nozzle guard to fit into place (Diagram 5).
IMPORTANT: BE SURE BELT IS NOT TWISTED AND BRUSH ROLL ROTA TES SMOOTHLY.
2.
Diagram 2 Diagram 3
Lift and remove brush roll.
Loop belt around motor shaft.
3.
Diagram 4
Insert brush roll into holder #1
then #2.
7
4.
#2
#1
BELT STYLE: 3
5.
Diagram 5
Replace nozzle guard.
e