Belt Or Brush Roll Removal And Replacement - Dirt Devil M089800 Owner's Manual

1 Screw
behind
caster
BELT OR BRUSH REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
I
BELT STYLE:
9
1
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR
BRUSHROLL.
1. Your cleaner is equipped with a rear belt and front belt (Diagram 1).
2. To determine which belt needs to be replaced, remove side of nozzle cover that contains the handle release pedal. Flip cleaner
over to expose nozzle base. Use a phillips screwdriver to remove the nozzle cover screw located behind the caster (Diagram 2).
3. Flip the cleaner so it is right side up. Remove nozzle cover (Diagram 3).
TO REMOVE AND REPLACE REAR BELT:
NOTE: The front belt must be removed from the small pulley before replacing the rear belt.
1. Remove and discard old belt. Slide the front belt off the small pulley (Diagram 4).
2. Loop rear belt around large pulley, then slide the belt onto the motor shaft, making sure belt is properly located on pulley and
aligned between the metal belt guide clips (Diagram 5). Return front belt to small pulley (Diagram 4).
IMPORTANT: ROTATE BRUSHROLL MANUALLY TO MAKE SURE BELT IS NOT TWISTED AND IS PROPERLY ALIGNED.
TO REMOVE AND REPLACE FRONT BELT OR BRUSHROLL:
1. Flip cleaner to expose nozzle base. Use Phillips screwdriver to remove the five nozzle guard screws (Diagram 6).
2. Remove nozzle guard (Diagram 7).
3. Lift and remove brushroll (Diagram 8).
4. Flip the cleaner right side up and discard of old belt.
5. Slide the new front belt over the small pulley (Diagram 4).
6. Guide belt thru the hole toward the brushroll area. Then flip cleaner over.
7. Slide the belt over the brushroll onto the area without bristles (Diagram 9a).
8. Replace brushroll into nozzle pocket (Diagram 9).
IMPORTANT: ROTATE BRUSHROLL MANUALLY TO MAKE SURE BELT IS NOT TWISTED AND IS PROPERLY ALIGNED.
9. Reattach nozzle guard (Diagram 7).
10. Secure by replacing the five nozzle guard screws (Diagram 6).
11. Reattach nozzle cover. Secure by replacing the screw under the nozzle base.
BELT STORAGE
Stretch belt around top two hooks on back panel (See Pg. 4, Figure 2 for belt storage location).