Table of Contents
Advertisement
4.
END CAP "_
BELT OR BRUSH REMOVAL
& REPLACEMENT
[BELT
STYLE: 4&5
]
TOOL REQUIRED:
PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL.
TO REMOVE
BELT
Flip cleaner to expose nozzle base. Base should lay flat and face up. To remove nozzle cover, use Phillips
screwdriver to remove the four screws. Arrows (Diagram 1) show location of screws. Flip cleaner back over and lift nozzle cover off.
Slide belt off motor shaft (Diagram 2). Lift and remove brushroll (Diagram 3). Dispose of old belt.
TO REPLACE
BELT
NOTE: When changing the belt, have height adjustment on lowest setting. This will make replacement easier.
1. Place belt on motor shaft, then slip brushroll through belt. Place belt in area of brushroll without bristles (Diagram 4).
2. With belt in place, pull and slide brushroll into nozzle (Diagram 3) making sure that the brushroll end caps are in the correct orienta-
tion (Diagram 3a inset).
IMPORTANT:
ROTATE BRUSHROLL MANUALLY TO MAKE SURE BELT IS NOT TWISTED.
3. Reattach nozzle cover. Secure by replacing the screws under the nozzle base.
BELT STORAGE
Stretch belt around hooks on back panel of upright (See page 4, Figure 2 for belt storage location).
LIGHTBULB
REMOVAL
& REPLACEMENT
TOOL REQUIRED:
FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134 or your local auto parts store.
1. Lean cleaner handle back. Insert end of standard (flat head) screwdriver into side slot and pry outward to pop headlight lens out
(Diagram 1).
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place.
Hide quick links:
Advertisement
Table of Contents
