How To Operate - Dirt Devil Vision Canister Owner's Manual

1.
Diagram 1
Line up hose adapter with hose
inlet on face of cleaner.
5
Diagram 5
Depress power switch with your foot to turn the Power Pak
nozzle on.
POWER NOZZLE ASSEMBLY (REFER TO FIGURE A).
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE
CONNECTING OR DISCONNECTING POWER NOZZLE.
1. Snap together the two interlocking wands until pin locks in place.
2. Push assembled wands into power nozzle.
3. Press cord into slots on back of wands.
4. Insert handle end of hose into assembled wands.
5. Plug power nozzle cord into hose.
HOSE INSTALLATION AND REMOVAL
WARNING: TO REDUCE THE RISK OF INJURY - UNPLUG CLEANER BEFORE REMOVING OR
INSTALLING HOSE.
1. Hold hose adapter so that cord is on the bottom.
2. Line up adapter with hose inlet hole on face of cleaner (Diagram 1).
3. Slide adapter into hose inlet hole and turn clockwise to lock (Diagram 2).
4. Give hose a slight tug to be sure it is in place securely.
5. Plug end of external hose cord into outlet on canister below the hose attachment area (Diagram 3).

HOW TO OPERATE:

1. Plug power cord into electrical outlet.
2. Turn canister "on" by depressing center switch labeled "push" on power control button (Diagram 4).
3. Select proper speed by rotating dial. Speed ranges from high to low.
4. Select carpet or bare floor cleaning.
a. Carpet Cleaning - Depress power switch with your foot to turn the power nozzle "on".
Be sure brush roll is rotating for effective cleaning and grooming.
b. Bare Floor Cleaning - Power nozzle:
nozzle off. Be sure brush roll stops rotating.
and attach brush to wands.
necting or disconnecting power nozzle.
ATTACHMENT INSTALLATION AND REMOVAL
1. Choose any of the handy accessories to meet your
firmly into the hose or wand end.
2. The hose can be used alone or with many combinations of wands and tools. Push the wand into
the hose handle until the pin locks into place.
3. To remove the tool, pull apart gently. You may gently rotate the attachment back and forth a little
to make the removal easier.
AUTO CORD WRAP
1. Push button for automatic cord rewind (Diagram 4).
2. Retractable cord is on the back of the canister (Diagram 6).
HOW TO ASSEMBLE & OPERATE
2.
Diagram 2
Slide hose adapter into hose inlet
and turn clockwise to lock.
6.
Diagram 6
Retractable power cord.
Depress the power switch again to turn the power
Bare Floor Brush: Disconnect power nozzle
NOTE: to reduce the risk of injury - unplug cleaner before con-
various cleaning needs.
To unlock the wand, push pin, rotate and then pull apart.
3.
Diagram 3
Plug cord into canister.
Then simply push it
5
4.
Cord rewind button
On/Off / Variable
power switch
Diagram 4
Power switch on canister and cord rewind but-
ton.
FIGURE A
4
1
2
Power Nozzle
5
3
3
3
3