Belt Or Brush Removal & Replacement; General Maintenance; Debris Removal - Dirt Devil Featherlitea Owner's Manual

Diagram 1 Remove & Replace Nozzle Guard
Diagram 2 Remove belt
Use Phillips screwdriver to remove 2 screws. Secure nozzle
Slide belt oft motor shaft.
guard
by
locabng h e
3
tabs in h e base and replacing screws.
BELT OR BRUSH REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
I I
Diagram 3 Brushroll
Diagram 4 Replace Belt
LiH and remove brushroll.
Place belt In area of brushroll
without br~stles.
1
BELT STYLE:
10
1
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL.
TO REMOVE BELT
Flip cleaner to expose nozzle base. Base should lay flat and face up. To remove nozzle guard, use Phillips
screwdriver to remove the two screws. Arrows (Diagram 1) show location of screws. Lift nozzle guard off. Slide belt off motor shaft
(Diagram 2). Lift and remove brushroll (Diagram 3). Dispose of old belt.
TO REPLACE BELT
1. Place belt on motor shaft, then slip brushroll through belt. Place belt in area of brushroll without bristles (Diagram 4).
2. With belt in place, pull and slide brushroll into nozzle (Diagram 3) making sure that the brushroll end caps are in the correct
orientation (Diagram 3a inset).
IMPORTANT: Rotate brushroll manually to make sure belt is not twisted.
3. Reattach nozzle guard. Secure by locating the 3 tabs in the base slots and replace the screws (Diagram 1).
DEBRIS REMOVAL:
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG BEFORE SERVICING.
1. Remove the four (4) screws located on lower backside of the cleaner (Diagram 1).
2. Remove the Access Panel. NOTE: Access panel should not detach completely from the unit. It should remain attached to the lower
hose (Diagram 2 & 3).
3. Remove all visible debris (Diagram 3).
4. Replace access panel and the four (4) screws (Diagram 4).
NOTE: Make sure to check inlet behind dirt cup for any clogs. Refer to Dirt Container: Removal and Replacement
-
pg. 6.