Brake Light Switches - Yamaha RAPTOR 700R Owner's Manual

1
2
3
(a)
4
5
6
1. Locknut
2. Brake lever free play adjusting nut
7
NOTE:
8
If the cable length cannot be adjusted to specifica-
tion, consult a Yamaha dealer.
9
4. Tighten the locknut on the brake cable.
10
EWB02030
11
POTENTIAL HAZARD
Operating with improperly serviced or ad-
justed brakes.
(b)
2
1
WARNING
WHAT CAN HAPPEN
The brakes could malfunction, causing re-
duced braking performance. This could in-
crease the chance of a collision or accident.
HOW TO AVOID THE HAZARD
After adjusting the parking brake free play,
block the rear of the ATV off the ground and
spin the rear wheels. Check to make sure
there is no brake drag. If brake drag is no-
ticed, perform the adjustment again.
EBU24740

Brake light switches

The operation of the brake light switches must be
checked and, if necessary, adjusted at the inter-
vals specified in the periodic maintenance and lu-
brication chart.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
NOTE:
The brake light switch is properly adjusted when
the brake light comes on just before braking takes
effect.
Turn the adjusting nut while holding the brake light
8-31