Yamaha RAPTOR 700R Owner's Manual page 100

1
1
2
3
4
2
5
6
1. Oil filter element
2. O-ring
7
9. Install a new oil filter element and the O-rings.
8
NOTE:
9
Make sure that the O-rings are properly seated.
10. Install the oil filter element cover by installing
10
the bolts, and then tighten them to the speci-
fied torque.
11
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
2
11. Install the crankcase engine oil drain bolt and
the engine oil tank drain bolt, and then tighten
them to the specified torques.
Tightening torques:
Crankcase engine oil drain bolt:
23 Nm (2.3 m·kgf, 16.6 ft·lbf)
Engine oil tank drain bolt:
19 Nm (1.9 m·kgf, 13.7 ft·lbf)
12. Install the engine oil filler cap, and then tighten
it to the specified torque.
Tightening torque:
Engine oil filler cap:
12 Nm (1.2 m·kgf,8.7 ft·lbf)
13. Pour only 1.3 L (1.37 US qt, 1.16 Imp.qt) of the
specified amount of the recommended engine
oil through the engine oil tank filler hole, and
then install and tighten the oil tank filler cap.
14. Start the engine, rev it several times, and then
turn it off.
15. Remove the engine oil tank filler cap, and then
gradually fill the oil tank with the remaining oil
quantity while regularly checking the oil level
on the dipstick.
8-13