Automatic Rxlev Indication +Cced - Wavecom WMO2 Manual

WCOM/GSM/WMO2/WMO2ATDOC
4.10.2 Automatic RxLev indication
The CCED command has been extended to indicate the the received signal
strength indication (rssi) of the main cell. The principle of the command is
not changed:
Command Syntax:
* <mode>:
0 One shot requested
1 Automatic shots requested
2 Stop automatic shots
* <requested dump>:
8 Main cell RSSI indications (RxLev) from 0 to 31
The response will be a +CSQ answer and not a +CCED answer. The 07.07
format for the +CSQ is respected. The <ber> is not evaluated by this
command, so the <ber> value will always be 99.
+CSQ:<rssi>, 99
OK
This +CSQ answer, when automatic shots are selected, is sent every time
the <rssi> measured by the module changes. This automatic shots are
supported in idle mode and during communication.
Combination (addition of the values) of the requested dumped (1,2,4,8) are
supported. Both answer +CCED and +CSQ may be then generated.
WAVECOM confidential ©
+CCED
AT+CCED=<mode>[, <requested dump>]
WMO2 G900 / G1800 / G1900
Friday 21 May 1999
74