Commands Set; General Commands; Manufacturer Identification +Cgmi; Request Model Identification +Cgmm - Wavecom WMO2 Manual

WCOM/GSM/WMO2/WMO2ATDOC

4 Commands set

4.1 General commands

4.1.1 Manufacturer identification +CGMI

Application to GSM
GSM to application

4.1.2 Request model identification +CGMM

Application to GSM
GSM to application
4.1.3 Request revision identification
Application to GSM
GSM to application
For the <CR> and <CR><LF> sequences are not
convenience
indicated in the examples shown in the following description.
This command gives the manufacturer identification.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
Example:
AT+CGMI
WAVECOM MODEM
OK
This command is used to get the supported bands (GSM 900, DCS 1800,
PCS 1900).
The answer could be a combination of different bands in the case of
multiband modem.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
Example:
AT+CGMM Get hardware version
900P GSM 900 MHz primary band, or
OK "900E" (extended band),
"1800" (DCS), "1900" (PCS) or
"MULTIBAND"
This command is used to read the software version.
It is only a read command.
There is no possibility to set a value or to test the parameters.
Command Syntax:
Example:
AT+CGMR
300_D250 641680 012099 18:10
OK
WAVECOM confidential ©
AT+CGMI
Get manufacturer
identification
Command valid, Wavecom
modem
AT+CGMM
AT+CGMR
get software version
Software release 3.00 generated on the
20 st of January 1999
WMO2 G900 / G1800 / G1900
Friday 21 May 1999
+CGMR
23