Monte Carlo Fan Company 3ACR52XXD Series Owner's Manual And Installation Manual page 5

19
Lift Conopy allowing the 2 studs to
protrude through the canopy.
Install knurled nuts and tighten the
knurled nuts securely. The canopy
should adjust for any irregularity in
the ceiling or outlet box.
22
L o o s e n 2 a n d r e m o v e 1
preassembled scews from the
plate on motor. Save screw for
later use.
25
Connect white wire from fan to
white wire from light fixture and
then connect black wire from fan to
black wire from light fixture.
© 2013 Monte Carlo Fan Company
20
Install blade bracket with blade by
3 blade screws provided. Tighten
securely. Repeat this process for
remaining blades.
23
Attach light pan on to the plate on
motor, aligning the keyhole slots
with the preassembled screws on
the plate. Twist clockwise till lock.
Install the screw removed in step
22. Tighten all screws securely.
26
Attach light fixture on to light pan,
aligning the keyhole slots on the
light fixture with the screws on light
pan and twist clockwise till tight.
Install the screw removed in step
24. Tighten all screws securely.
5
21
Install the blade assembly to motor
using the pre-installed screws.
Tighten screws securely. Repeat
this process for remaining blade
assemblies.
24
L o o s e n 2 a n d r e m o v e 1
preassembled screw from light
pan. Save screw for later use.
27
Install 75-watt JDE 11 base bulb. Bulb
included. WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed.Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Note: Do not replace bulb until it cools
down.
7/1/2013