Monte Carlo Fan Company 3ACR52XXD Series Owner's Manual And Installation Manual page 4

10
Install keeper pin.
13
Hang assembled fan from the mounting
bracket installed to ceiling in previous
step. Make sure the fan is hanging
straight. Rotate fan until the tab on the
Mounting bracket engages the slot on the
Downrod Ball. This must be done to
prevent the fan body from rotating
when the blades are in motion.
16
Install remote receiver into
the mounting bracket.
© 2013 Monte Carlo Fan Company
11
E v e n l y t i g h t e n t h e 2 s e t
screws on the yoke, once the
down rod is in place.
Safety cable installation
14
Safety cable
Lag screw
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3" lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended
the leadwires are longer than the cable and no
stress is placed on the leadwires.
Note : If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In The
Outlet Box.
17
Supply
circuit
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Grounded wire from
House.
4
12
M a k e s u r e t h e s t u d s
protruding from the bottom
of the Mounting bracket are
installed with threads all the
way through the bracket.
15
Remote transmitter dip switch
Remote receiver dip switch
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
T h i s m u s t b e d o n e s o t h e u n i t s w i l l
communicate properly. If you have other fans
you can set to control from one transmitter
by setting both receivers the same as the
transmitter. If you have more than one fan
with remote. You can set the dip switches to
different positions to have separate control.
18
Make wire connections to power source using
wire nuts provided. Make sure that no filaments
are outside of the wire nut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
7/1/2013