Resetting The Gigaset Usb Adapter - Siemens Gigaset USB Adapter DECT Operating Instructions Manual

Installation
ì ì ì ì
Click browse and enter the following file: xxx
ì ì ì ì
Confirm installation of the USB driver with OK.
During further installation, the configuration dialogue for your Gigaset USB Adapter will
be opened. The Gigaset USB Adapter is assigned a COM port.
After the USB Adapter has been installed, the wizard will install the software for your
base station and any additional software required.
ì ì ì ì
Confirm successful installation with Close.
ì ì ì ì
Depending on the operating system, you may be prompted to reboot your PC.
If you want to install Acrobat® Reader, cancel automatic reboot, install
i
Acrobat® Reader, and then reboot the PC manually.

Resetting the Gigaset USB Adapter

If you have already started using the Gigaset USB Adapter, but now want to install it with
a different base station, you should first reset the USB Adapter to its default settings. All
the data and registrations you have changed or made will be deleted.
ì ì ì ì
Run the Gigaset USB Adapters configuration program:
Start > Programs > Gigaset > Configuration of USB Adapter
ì ì ì ì
Select the Local adapter tab.
ì ì ì ì
Select Reset and confirm the warning prompt.
ì ì ì ì
You should also reset the registration of the registered partner stations.
ì ì ì ì
Close the configuration program.
After resetting, you can reinstall the T-Sinus 721. Follow the instructions in Chapter
"Installing the Gigaset USB Adapter DECT" on page 8.
10