Connecting The Remote Control Unit - Sony HDCAM HDW-700A Operation Manual

5-10 Connecting the Remote
Connecting the RCP-700 Series Remote Control Unit (not supplied)
enables remote control of the principle camera functions.
Turning the POWER switch of the camcorder to ON when the remote
control unit is connected to the REMOTE connector (8-pin)
automatically puts the camcorder into remote control mode. If you
disconnect the remote control unit, remote control mode is canceled.
Notes
• Always turn the POWER switch to OFF before connecting or
disconnecting the remote control cable.
5
• When you turn off the camcorder power, the settings and adjustments
made with the switches and controls of the remote control unit are
canceled. The settings and adjustments made with the setup menu are
saved, but some of them are not written in the setup card.
Connecting the RM-B150 Remote Control Unit (not supplied)
Use the black cable supplied with the RM-B150 to connect the monitor
output connector (Y signal) on the camcorder to the monitor input
connector on the RM-B150. To output the character information that is
displayed in the viewfinder screen as well, push the VF DISP switch on
the camcorder to MENU while holding the MENU switch on the RM-
B150 in the CANCEL position.
5-36 Chapter 5 Setting Up the Camcorder
Control Unit