Table of Contents
Advertisement
Port LEDs
10/100/1000Base-
T Twisted Pair
Port LEDs
The following sections describe the twisted pair port, SFP, and XFP LEDs.
See Figure 13 for an illustration of the port LEDs on an x600-24Ts/XP.
PORT ACTIVITY
K /
ACT
10/100 LINK /
HDX /
COL
XFP
L/A
26
Figure 13. Port LEDs on an x600-24Ts/XP Switch
A twisted pair port has two LEDs labeled L/A (link/activity) and D/C (duplex
mode/collisions). The L/A LED indicates the speed and activity on a port.
The D/C LED indicates the duplex mode (full- or half-duplex) and the
status of collisions on the port.
The twisted pair port LEDs appear on the right side of the x600-24Ts and
x600-24Ts/XP faceplates. On the x600-48Ts and x600-48Ts/XP
faceplates, the twisted pair port LEDs are interspersed among the twisted
pair ports.
Table 3 describes the LEDs for the 10/100/1000Base-T twisted pair ports.
Table 3. Twisted Pair Port LEDs
LED
Function
L/A
Link Status
and Activity
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
x600-24Ts/XP
ACT
SD
READY
BUSY
FAULT
STACK
1
3
5
7
9
11
13
15
17
19 21R 23R
MSTR
L/A
1
L/A
D/C
2
L/A
L/A
PRES
D/C
2
4
6
8
10
12
14
16
18
20 22R 24R
State
Off
No link has been established between
the port and the end node.
Green
The port has established a link at
1000 Mbps.
Flashing
Packets are being received or
green
transmitted at 1000 Mbps.
Amber
The port has established a link at 10
or 100 Mbps.
Flashing
Packets are being received or
amber
transmitted at 10 or 100 Mbps.
Layer 3 Gigabit Ethernet Switch
SFP
CONSOLE
STATUS
L/A
21
FAULT
22
MASTER
RPS
23
RESET
24
PWR
1312
Description
25
Advertisement
Table of Contents
