Playback From External Components - Kenwood R-K731 Instruction Manual

External Components
This section explains how to connect external components to the system and play back tracks.
46
R-K731

Playback from External Components

Connect the external component to the system as described in <Connecting
Other Accessories (Commercially Available Units)> (P.12, 13).
When connecting external components, always turn this system and the external com-
ponents off beforehand.
Also refer to the instruction manual that comes with the external component being
connected.
1 1
Press the [D-IN1/2] key to perform playback from a device
connected to the [DIGITAL IN] terminal, while you press the
[AUX] key to perform playback from a device connected to
the [AUX PLAY IN] terminal.
2 2
Begin playback on the connected external component.
Perform the required operation on the connected external component to start
playback.
3 3
Adjust the volume level.
When a digital component is
selected, the input signal sam-
pling frequency is displayed.
The system will play PCM
(32, 44.1, 48, 88.2, 96 kHz)
digital signals.