Playback From External Components - Kenwood K-521 Instruction Manual

External Components
This section explains how to connect external components
to the system and play back tracks.
42
K-521

Playback from External Components

Connect the external component to the system as described in <Connecting
Other Accessories (Commercially Available Units)> (P.13).
When connecting external components, always turn this system and the external com-
ponents off beforehand.
Also refer to the instruction manual that comes with the external component being
connected.
1 1
Press the [D-IN] key when playback is performed from a de-
vice connected to the [DIGITAL IN (OPTICAL) ] terminal, while
press the [AUX] key when playback is made performed from
a device connected to the [AUX IN] terminal.
2 2
Begin playback on the connected external component.
Perform the required operation on the connected external component to start
playback.
3 3
Adjust the volume level.
When a digital component is se-
lected, the input signal sampling
frequency is displayed.
The system will play PCM (32, 44.1,
48, 88.2, 96 kHz) digital signals.