Connecting The Speakers - Kenwood R-K731 Instruction Manual

Microcomputer malfunctions
Connecting the AM loop antenna
The antenna supplied with the system is for indoor use. Place it as far as possible away from the main unit,
your TV set, the speaker cords and the power cord and point it in the direction that gives the best reception.
Connecting the antenna cord
As shown on the right, connect the AM
antenna cord to the [AM] terminal.
Connecting the FM indoor antenna
The antenna supplied with the system is a basic antenna for indoor use. For stable signal reception, the
use of an outdoor antenna (commercially available) is recommended. To connect an outdoor antenna, fi rst
remove the indoor antenna.

Connecting the speakers

Notes on connecting the
speaker cords
Connecting the speaker cords to the main unit
If the system is connected correctly and still does not operate
normally or shows display errors, reset the microcomputer. (P.73)
1 2
Never short-circuit the positive (+) and negative (–) ends of the
speaker cords. (Do not touch the + and - cords together.) Mis-
takenly reversing the positive and negative polarity will result in
unnatural sound and unclear sound.
1 2
Connecting the System
3
3
11
English