Adjustment Of Input Levels From External Components; Switching The Displayed Information - Kenwood R-K1 Instruction Manual

Adjustment of Input Levels from External Components

The level of the analog signal input from each external compo-
nent can be adjusted independently for the [PHONO], [MD],
[TAPE] and [AUX] input sources. Adjust the input levels so that
the audio from the external components are played at a similar
volume to CD playback.
Preparations
÷ Connect the external components in advance as de-
scribed in "Connecting Associated Products (Com-
mercially Available)". (See page 9.)
÷ Switch the external components ON.
1 Perform the procedure in "Basic Operation" till step
the [PHONO], [MD], [TAPE] or [AUX] input (see page 14.)
2 Enter the input level adjustment mode
3 Adjust the input level

Switching the displayed information

32
EN
1 Press the MODE key
2 Select [Input Level]
Advance
Enter the
selection.
\
Return
Increase
Enter the
selection
\
Decrease
PHONO MD TAPE
AUX D-IN 1 D-IN 2 DIMMER
TIMER
SLEEP
TIME/PTY
CLEAR DISPLAY
OPEN/
P.MODE RANDOM REPEAT CLOSE
MODE MUTE
AUTO/MONO DIRECT
TUNER CD D.AUDIO
BASS TREBLE FOLDER
PREV. NEXT
BALANCE
: Keys and controls used in the operation.
I n p u t
I n p u t L e v e l
÷ The input level display starts to blink. (Begin the level adjust-
ment within 20 seconds after the display appears.)
I n p u t L e v e l
÷ The level can be adjusted in three steps of -6, -3 and 0. (Begin
the level adjustment within 20 seconds.)
÷ When the input level is adjusted so that the audio from the se-
lected external component is played at a similar volume to CD
playback, the level of recording the signal from the input con-
nector is also adjusted to a similar level regardless of the input
source component. Therefore, do not vary the input level in the
middle of recording as this will vary the recording level.
Each press switches the selection.
1 Input selection display
2 Day of the week and time of day display
2 to select
L e v e l
«
0
- 6