Connecting A Pc And Playing Its Contents - Kenwood R-K731 Instruction Manual

PC
On this system you can listen to the music stored in your PC.
44
R-K731

Connecting a PC and Playing Its Contents

Prepare a USB cable (Type A – Type B) for use in connection of the PC to this system
(See P.12).
1 1
Connect the USB port of the PC to the [PC IN] terminal on
the rear panel of the main unit using the USB cable.
Turn this system off before connecting the PC to it.
2 2
Turn the PC on.
3 3
Turn this system on.
The driver software is installed automatically in the PC, which recognizes this
system as "USB speaker".
Do not disconnect the USB cable while the PC is detecting the connection of
this system.
If the PC does not recognize this system in a few seconds, try to:
– Disconnect the USB cable and connect it again.
– Reboot the PC
4 4
Press the [PC IN] key.
5 5
Control the PC software and open an audio fi le.
The audio fi le should be selected on the PC. For the operations of the PC, refer
to the manuals for your PC and the software.
The volume can be controlled on this system.
" " is displayed while the PC is connected.
This system is compatible with 32 kHz/44.1 kHz/48 kHz sampling frequencies.
It can receive 16-bit stereo/monaural data.
The [PC IN] terminal of this system is used exclusively for input. It is not
possible to record the audio played on this system into the PC.