March 2013
Configuring SIP Call Control Protocol
The section contains the following procedures.
Configuring Direct Routing by the Application on page 72
Configuring SIP Call Control with Gateway or IP-PBX on page 73
Configuring SIP Call Control with a Proxy Server on page 74
Configuring Direct Routing by the Application
If you chose to configure the SIP Call Control protocol the following
screen appears:
Follow the steps below to configure Direct Routing by the
Application.
1. Select Direct routing by the Application.
2. There is no routing configuration required because the
application routes the call. Click Next and refer to
SIP Fax Setup on page 79
Configuring in Wizard Mode
Configuring
72