March 2013
Configuring H.323 Call Control
You can configure H.323 Call Control three ways:
Configuring H.323 Direct Routing by the Application on page 80
Configuring H323 Call Control with a Gateway on page 81
Configuring H.323 Call Control with a Gatekeeper on page 82
Configuring H.323 Direct Routing by the Application
If you chose to configure the H.323 Call Control, protocol the
following screen appears.
Follow the steps below to configure Direct Routing by the
Application.
1. Select Direct routing by the Application.
2. This is no routing configuration required because the application
routes the call. Click Next and refer to
Setup on page
84.
Configuring in Wizard Mode
Configuring H.323 Fax
80