Table of Contents
Advertisement
3. Installing the Digital Camera.
Check the digital camera.
Check the digital camera before installing it in the Case.
Battery check
As the LCD monitor is used for picture confirmation when taking
pictures, the battery tends to be used up quickly. Confirm that the
remaining battery capacity is sufficient.
Checking the number of pictures remaining to be taken
Make sure that the number of remaining pictures available is sufficient.
Removing the hand strap from the digital camera
If a hand strap is attached to the digital camera, it must be removed.
CAUTION
: • If a digital camera is loaded without removing the strap,
the strap may get caught between the case lids and may
cause water leakage.
• Handle the digital camera carefully when removing the
strap. OLYMPUS IMAGING CORP. shall not be
responsible for damage caused by dropping the camera.
Loading the camera in the case
Which digital cameras can be loaded?
This case (CWPC-01) is exclusively for the µ-mini DIGITAL/Stylus
Verve.
Turn on the camera.
Press the power button on the digital camera once to switch it on.
Pressing the same button again switches it off.
If the camera is not operated for about three minutes, it will enter
the sleep mode (standby condition) and stop operation. To return to
the active mode, just press any operation button such as the zoom
button. If the camera is left untouched for more 12 minutes, it will
switch off completely. In this case, switch it on again on by pressing
the power switch button.
E-12
Advertisement
Table of Contents
