Sharp SJ-PV50H-W Operation Manual page 17

Do not use polishing powder, benzine, hot
water etc.
If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
Wipe any food oils adhered to plastic components
as they can cause cracking of the plastic surface.
Clean once a year
Evaporating pan / Evaporating pan cover
Water will be difficult to evaporate when dirty. Also remove dust from the inside of the evaporating pan cover.
Hold both sides of the evaporating
Removing
pan cover and angling upward.
Pull the evaporating pan out.
Evaporating pan
Hold level to Evaporating
pan cover
avoid spilling
Water leakage and abnormal noise may occur when evaporation pan and cover are not properly mounted.
Back of refrigerator, floor and walls
There may be build-up of dust from convection of air.
Turn the right and left adjustable feet until
they are off-ground and move the refrigerator.
Adjustable foot
Evaporating pan cover
(right and left)
Notes
About the stainless tray
Salt adhered on the tray may cause rusting. In this case, clean the tray
with kitchen detergent (cream-type cleanser, etc.) as quickly as possible.
Do not use nylon scrubbing brushes. The tray may become scratched.
When using chemical rags, be sure to follow the accompanied
directions.
Mounting
Pull diagonally
upward
Handle to the front
Wipe off dirt.
Dust and soil
Wipe off dust
from the power
plug as well.
Put the evaporating pan
Fit the pawls of the evaporating pan
on the radiator plate, and
cover into the holes of the cabinet,
then slide it in completely.
and then push the cover to attach.
Push into main
unit holes
Tab (right / left)
Remove dust from the
holes on the lower
section of the back side
using a vacuum cleaner.
39