Sleep Operation - Sharp XL-MP50H Operation Manual

7
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the volume
you were listening at before your system enters the timer stand-
by mode.
8
The unit will enter the stand-by mode one hour after the
timer playback starts. However, when disc or tape play-
back time is one hour or less, it will enter the stand-by
mode after completing playback.
To reset or change the timer setting:
Perform "Timer playback" from the beginning.
Note:
When performing timer playback using another unit connected to
the VIDEO/AUX sockets, select "VIDEO/AUX" in step 2. At this time,
only this unit will be turned on or enter the power stand-by mode
automatically. It will enter the power stand-by mode 1 hour after the
timer playback starts. However, the other unit will not be turned on
or off.

! Sleep operation

1
Play back the desired sound source.
2
Press the SHIFT button and then the
SLEEP button.
To change the sleep time:
Time decreases as follows each time they are pressed.
The amount of sleep time can also be changed whilst in the
sleep mode.
(Maximum: 3 hours - Minimum: 5 minutes)
3:00 2:00 1:30
OFF 5 10
3
Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will turn down 30 seconds before the sleep opera-
tion finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, press the SHIFT button and then the SLEEP button
until "OFF" appears on the display.
To confirm the remaining sleep time:
Press the SHIFT button and then the SLEEP button once whilst the
sleep timer is set.
The remaining sleep time is displayed for about 3 seconds.
05/3/24 XL-MP50H(H)E3.fm
XL-MP50H
ENGLISH
1:00
15 30
E-28
TINSZA054SJZZ
8