Recording On A Cassette Tape - Sharp XL-MP50H Operation Manual

Recording on a cassette tape

XL-MP50H
ENGLISH
Before recording:
" When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
" SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
" The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
" For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
E-25
Erase-prevention tab of cassette tapes:
" When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent acciden-
tal recording or erasing.
" To protect the recorded sound, re-
move the tab after recording. Cover
the tab hole with adhesive tape to
record on the tape without the tab.
! Recording from a disc
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD DISC" appears on
the display.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
" Recording will be paused.
" On the remote control, press the SHIFT button and then the
button.
6
Press the ( ) button to start recording.
" Playback of the disc will start in a few seconds after the tape
starts.
" When the playback of the disc is finished or the end of the
tape is reached, the disc and the cassette will stop automat-
ically.
05/3/24 XL-MP50H(H)E3.fm
Side A
Tab for Tab for
side B side A
TINSZA054SJZZ