Setting Procedure - Siemens HL 65024 Instruction Manual

Setting procedure

l Dual circuit
hotplate
m Hotplate with
extended cooking
zone
Tables
Use the hotplate controls to set the heat setting of the
individual hotplates. The selected heat setting can be
seen in the digital display on the hob.
0 = hotplate off
1 = lowest setting
9 = highest setting
You may select intermediate steps between settings
1 and 9. These are marked by a dot. You will feel
slight resistance between settings 3 and 4.
An end stop is fitted at the end of the setting range.
Please do not turn the switch beyond this point.
The size of these hotplates can be altered.
Activating the large hotplate:
Turn the hotplate control to setting 9 - you will feel
light resistance - and then clockwise to
l = large dual circuit hotplate or
m = extended cooking zone.
Then select the required heat setting immediately.
Switching back to the small area:
Turn the hotplate control back to 0 and reset it
N.B. Never switch the hotplate control beyond the
symbol to 0.
The dual circuit hotplate is particularly suitable for
heating up small quantities of food.
The following table provides you with a few examples.
Please remember that the cooking times depend on
the type, weight and quality of the food, which means
that deviations are possible.
Set the cooking zone control to setting 9 for bringing
to the boil or initial frying. Then switch the control back
to the appropriate simmer setting.
.
21