Table of Contents
Advertisement
Settings for the video recorder
Child lock
In the "Settings" menu, you can activate the
child lock. With the child lock activated and the
video recorder set to standby, the video
recorder cannot be used. However, the remote
control can still be used for operation.
You must therefore store the remote control out
of the reach of children.
To activate/deactivate the child lock:
M
Call up VCR menu
Highlight "Settings"
OK
Call up "Settings"
Highlight "Child lock" (via
"other")
–––––––––––
./Settings
others ...
Child Lock
Autom. switch off
AV Control Voltage
Decoder at AV2
Power save Standby
Select
and set
Switch child lock on/off
A video that is running can be watched to the
end or stopped on the video recorder.
Note that the Loewe remote controls for TV
sets and DVD players can be switched to VCR
operation, so make sure these are also stored
out of the reach of children.
22
BA_VCR_31251_020EU_GB2
Switch off automatically
Five minutes after the last operation the video
recorder switches automatically to Standby in
Stop Mode if there is no menu open and if
"Autom. switch off" is set to "Yes".
M
OK
–––––––––––
On
Yes
On
No
Off
Back
M
E
End
22
Call up VCR menu
Highlight "Settings"
Call up "Settings"
Highlight "Autom. Switch off"
(via "others")
–––––––––––
./Settings
–––––––––––
others ...
Child Lock
On
Autom. Switch off
Yes
AV Control Voltage
On
Decoder at AV2
No
Power save Standby
Off
Select
M
Back
and set
E
End
Autom. Switch off Yes/No
17.04.2003, 15:30 Uhr
Control voltage via Euro AV cable
The control voltage of the video recorder
causes the TV set to switch over to the display
of the signal. Therefore, at the start of play it
appears immediately on the TV set. If you
rewind or fast forward, the station received by
your video recorder will be displayed on the
screen of your TV set. In this case, you cannot
switch to another station on your TV set.
If your TV set has Digital Link Plus you may be
able to dispense with the control voltage, as
the TV set switches over without control
voltage when the video is playing.
If you have connected your video recorder to
the TV set without Digital Link Plus or a
comparable system and de-activated the
control voltage, you must select the AV
programme on the TV set when playing. This
differs from set to set; refer to the operating
instructions of your TV set.
M
Call up VCR menu
Highlight "Settings"
OK
Call up "Settings"
–––––––––––
./Settings
–––––––––––
others ...
Child Lock
Autom. switch off
AV control Voltage
Decoder at AV2
Power save Standby
Select
and set
Highlight "Control voltage"
(via "other")
Control voltage off/on
On
Yes
On
No
Off
Back
M
E
End
Hide quick links:
Advertisement
Table of Contents
