Functional Description - Makita 9560C Instruction Manual

FUNCTIONAL
DESCRIPTION
1
1. Shaft lock
1. Slide switch
2
1. Speed adjusting dial
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Shaft lock
002978
CAUTION:
• Never actuate the shaft lock when the spindle is moving. The tool may be
damaged.
Press the shaft lock to prevent spindle rotation when installing or removing
accessories.
Switch action
001035
1
CAUTION:
• Before plugging in the tool, always check to see that the slide switch
actuates properly and returns to the "OFF" position when the rear of the
slide switch is depressed.
To start the tool, slide the slide switch toward the "I (ON)" position. For continu-
ous operation, press the front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then slide it toward the
"O (OFF)" position.
Speed adjusting dial
For 9560CV, 9561CV, 9562CV, 9563CV, 9564CV, 9565CV
001046
The rotating speed can be changed by turning the speed adjusting dial to a
given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the direction of number 5.
And lower speed is obtained when it is turned in the direction of number 1.
Refer to the below table for the relationship between the number settings on
the dial and the approximate rotating speed.
1
CAUTION:
• If the tool is operated continuously at low speeds for a long time, the
motor will get overloaded and heated up.
• The speed adjusting dial can be turned only as far as 5 and back to 1. Do
not force it past 5 or 1, or the speed adjusting function may no longer
work.
Number
1
2
3
4
5
C00025
-1
min (R.P.M.)
2,800
4,000
6,500
9,000
11,000
5