Connecting The Mediamaster; Front And Rear Panel; Preparing The Remote Control - Nokia Mediamaster 120 C User Manual

Connecting the Mediamaster

Front and Rear panel

antenna cable
for connection of the antenna cable
to the cable TV antenna socket
DC in
for connecting the cable
from the external power
supply
Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected; 1.0 m)
• an Introduction Guide
• a separate power supply
• an RF cable

Preparing the remote control

• Remove the cover from the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
* * The TV SCART Socket
When you connect other devices to this socket, always use a fully
connected SCART cable like the one supplied. There are SCART
cables available that do not have all the pins connected,
which could reduce picture quality if you were to use them.
Reset button
TV/VCR
For connecting to the
RF socket on the TV,
or to a Video
recorder
Slot
for a Conax smart card
TV SCART socket * *
for connection to the TV SCART
Digital audio
Digital audio output
(TOS-link optical
connection)
A constant green light indicates that the Mediamaster is
switched ON.
A constant red light indicates standby mode.
The light flashes red when commands from the remote control
are received.
The light flashes green during software updates.
Power supply
SCART
cable
GB 5