Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected; 1,0 metre)
• mains cable
• RF cable
• Owner's manual including a software license agreement
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other devices to any
of these sockets, always use fully connected SCART cables (as
the one supplied.) There are SCART cables available which do not
have all the pins connected. The picture quality could be reduced
if you use them.
Preparing the remote control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA; 1,5 V batteries, as shown in the diagram, tak-
ing care to observe the + and - markings indicated inside.
• Replace the cover.
About the digital transmission
Digital Radio and TV signals can be blocked by buildings, moun-
tains and the terrain. Depending on if the receiver is located in a
valley, behind a mountain or in a concrete building, the quality of
reception may vary considerably.
As with most other transmissions, bad weather does affect the
reception quality.
SCART cable
RF cable
Remote control
Owner's Manual
SCART socket
Mains cable
GB 7