Table of Contents
Advertisement
Installation of the Mediamaster
The Mediamaster box should contain the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected 1.0 metre)
• a mains cable
• an owner's manual with the software license agreement
About the SCART sockets
The rear panel of the Mediamaster contains 2 SCART sockets (see diagram). When
you connect other devices to any of these sockets, always use fully connected
SCART cables (as supplied). There are "less well specified" SCART cables on the
market and picture quality could be reduced if they are used.
Preparing the remote control
• Remove the cover from the battery compartment at the bottom of the remote
control.
• Insert the 2 AAA (1.5 V) batteries, as shown in the diagram.
Make sure that you observe the + and - markings indicated inside.
• Replace the cover.
Connecting the Mediamaster to the dish
If you need to fit the F-connectors onto the cable
• Prepare each end of the cable as shown in the diagram. You will need to fold
back the outer braid (as shown).
• Slide the F-connector onto the cable and then turn it clockwise until it grips the
braid.
• Ensure that 3 mm of the core is protruding from the end of the connector.
Installing the satellite dish
• See the Fitting instructions provided with your satellite dish on how to install the
dish.
• Connect the coaxial cable, with the F-connectors fitted, from the LNB on the sat-
ellite dish to the socket marked "ANTENNA"on the rear panel of the
Mediamaster.
General
There are many different types of TV/VCR and other equipment that you can con-
nect to the Mediamaster.
In this manual, you will see some of the most common ways to connect your equip-
ment.
If you have problems with your connections and need help, please contact your
dealer.
SCART
Remote
Mains
cable
control
cable
SCART socket
x
15 mm
8 mm
F-connector
3 mm
Owner's
manual
GB 11
Advertisement
Table of Contents
