Connecting To Tv And Vcr; First Time Installation; Basic Operations; Switching On And Off - Strong PRIMA III User Manual

PART 1 • English

3.2 Connecting to TV and VCR

NOTE: When connecting the receiver to other equipment, e.g., TV, VCR and amplifier, make sure to refer to relevant
user manual for instruction. Also, make sure you disconnect all the equipments from the mains supply before
the connection. (Fig. 5)

4.0 FIRST TIME INSTALLATION

After all the connections have been made properly, switch on your TV. Make sure the receiver is connected to the mains
and press Power to switch the receiver on. If you are using the receiver for the first time, a Setup - Installation menu will
be displayed to guide you through the initial setup. Use the remote control to finish the setup.
1. At the Setup - Installation menu, select in first step your regional settings, accordingly to your region and
settings you prefer.
2. Select then following settings Antenna Power, Country Setting, OSD Language, Audio Language, Subtitle
Language, LCN, Time Zone. If you use an active antenna please select Antenna Power to ON.
For well known countries where the Logical Channel Numbering is provided the LCN mode is
automatically set to ON, but if your country is providing LCN although, then you can switch ON. If you
aren't sure on that point please leave it switched OFF.
(Scr. 1) Press q to adjust time settings (Scr. 2)
NOTE: Make sure to select the region you are located since the receiver will scan the channels based on the
bandwidth of the region you selected. If your region is not on the list, you are recommended to conduct a
manual search. Press Manual Search (GREEN) button on remote control.
3. Then select Auto Scan (RED) to proceed (Scr. 3)
4. Wait to complete the scanning.
In case you want to stop the scanning, press the EXIT key. The channels already found will still be stored.
(Scr. 4)
5. When finished, all channels found will be stored automatically. The first found channel will be played. Refer
to chapter Country Setting & Program Search. (Scr. 5)
Now you are ready to watch digital terrestrial TV channels and radio broadcasts.
In case you skip the Setup - Installation screen, you can still specify your Country Settings and Program Search via the
on-screen setup menu.
The Country Setting & Program Search menu can be accessed via Main Menu >Installation. Refer to chapter Country
Setting & Program Search.

5.0 BASIC OPERATIONS

Once program search is completed, you can start to watch digital terrestrial TV and radio channels. Some typical
operations are given in this chapter.

5.1 Switching On and Off

Whenever you are not using the receiver, press the STANDBY key on remote control to put it into standby mode.

5.2 Changing Channels

To switch between different channels, you can:
Press OK to display the channel list and p/q to select a desired channel.
n
Press the p/q key or buttons on the receiver to go to the previous/next channel.
n
Use the numeric keys to select a channel number.
n
Use the RECALL key to return to the previous viewed channel.
n
Whenever you change a channel, a banner appears at the bottom of the screen displaying the basic information on the
current channel. (Scr. 6)

5.3 Adjusting the Volume

Press the t/u key to adjust the volume. (Scr. 7)
5