Activating/Deactivating The Suppression Of The First Ring Tone; Activating/Deactivating; Advisory Tones - Siemens Gigaset C345 Operating Instructions Manual

You can also set different melodies for the
following functions:
u
External Calls: For external calls
u
Calls: For internal calls
Internal
To find out how to set ring tones for the
base, see page 37.
Setting ringer volume
The ringer volume is the same for all types
of ring.
With the handset in idle status, open the
menu
Ringer Volume
briefly.
¢
Audio Settings
§Menu§
q
Adjust the volume and
press
§OK§
a
Long press (idle status).
Setting ringer melody
Set different ringer melodies for external
and internal calls.
¢
Audio Settings
§Menu§
Select External Calls
Calls and press
q
Select melody (‰ = on) and
press
§OK§
a
Long press (idle status).
Activating/deactivating the ringer
You can turn off the ringer on your hand-
set before you take a call or while the
phone is in the idle state. The ringer can-
not be re-activated while an external call is
in progress.
Deactivating the ringer
P
Press the star key and hold
until you can no longer hear
the ringer tone.
Re-activating the ringer
P
Press the star key long.
by pressing t
¢
Ringer Volume
.
¢
Ringer Melody
/ Internal
.
§OK§
.
Activating/deactivating the
suppression of the first ring tone
The phone identifies an incoming SMS
from the first network signal.
5 4 O 1 O
§Menu§
1
To suppress the first ring tone.
§OK§
Or:
Q
To hear the first ring tone.
§OK§
Please note:
If first ringer tone suppression is deacti-
vated, then every incoming SMS will be
signalled by a ring tone. If you take this
type of "call" at the first ring tone, you will
lose the SMS.

Activating/deactivating

advisory tones

Your handset uses 'advisory tones' to tell
you about different activities and statuses.
The following advisory tones can be acti-
vated and deactivated independently of
each other:
u
Key beep: Each key press is acknowl-
edged.
u
Acknowledge tones:
– Confirmation beep (rising tone
sequence): at the end of an entry/
setting, when the handset is placed
in the base station and on arrival of
an SMS or a new entry in the
answering machine list or the calls
list.
– Error beep (descending tone
sequence): when you make an
incorrect entry.
– Menu end tone: when scrolling at
the end of a menu.
u
Battery low beep: the battery needs to
be charged.
The confirmation beep when the handset
is placed in the base cannot be deacti-
vated.
Handset settings
35