Table of Contents
Advertisement
STATUS MESSAGES
If any of the following messages appears in the display, carry out the prescribed remedy.
Message
(Maintenance icon)
Maintenance required
soon.
Maintenance required.
Call for service.
Call for service.
(Toner cartridge
replacement required icon)
Toner is low.
Check the toner cartridge. Check to see if the toner cartridge has been installed properly.
Can not continue.
Remove paper from the
centre tray.
Please check paper in paper
tray<✼>.
Load <✼✼> paper into
tray <✼>.
Selected paper tray is out of
service.
Check stapler or staple jam.
Please remove paper
from the stapler compiler.
Please check the
original size.
Job is canceled.
<✼>: paper tray number
<✼✼>: paper size to be set
68
Service by an authorised SHARP service technician will be
required soon. Contact your service centre as soon as possible.
(This message will be displayed if the information key is
pressed when the information (
Normal maintenance service by an authorised SHARP service
technician is needed. Contact your service centre.
A malfunction has occurred which cannot be corrected by the
key operator. Contact your authorised SHARP service centre
for service.
Replacement of the toner cartridge will be needed soon. (This
message will be displayed if the information key is pressed
when the information (
The number of copies on the centre tray has reached the limit.
Remove the copies from the centre tray.
Check to see if copy paper has been loaded properly.
The paper size specified for the tray is different from the actual
size. See page 80.
Contact your authorised SHARP service centre for service.
Staples become jammed or the staple box is not installed
properly (when an optional finisher is installed). Check the
staple box. See page 112 for staple jam removal. If the trouble
cannot be easily remedied, use key operator program
"DISABLE STAPLER" to prevent the use of the stapler until it
can be repaired. Contact your authorised SHARP service
centre for service.
5 KEY OPERATOR See page 135 for enabling/disabling
stapler.
Paper is left in the stapler compiler. Remove it. See page 114.
The actual original size is larger than the detected size. Place
the originals again to ensure that the size indicated in the
display is the same as the actual size and then press the
START ( ) key.
Remedy
) icon is displayed.)
) icon is displayed.) See page 84.
Advertisement
Table of Contents
