Table of Contents
Advertisement
COPIER INSTALLATION
Improper installation may damage the copier. Please note the following during initial installation and
whenever the copier is moved.
CAUTION:
If the copier is moved from a cool place to a warm place, condensation may form inside the
copier. Operation in this condition will cause poor copy quality and malfunctions. Leave the
copier at room temperature for at least 2 hours before use.
Do not install your copier in areas that are:
q
damp, humid, or very dusty
q
poorly ventilated
The copier should be installed near an accessible power outlet for easy
connection and disconnection.
Be sure to connect the power cord only to a power outlet that meets the specified
voltage and current requirements (See page 91.). Also make certain the outlet is
properly grounded.
q
For this copier's power supply requirements, see the name plate located on the back of the unit.
NOTE:
Connect the copier to a power outlet which is not used for other electric appliances. If a lighting
fixture is connected to the same outlet, the light may flicker.
Be sure to allow the required space around the machine for servicing and proper
ventilation.
q
exposed to direct sunlight
q
subject to extreme temperature or
humidity changes, e.g., near an air
conditioner or heater.
30 cm (12")
1
9
Advertisement
Table of Contents
