Table of Contents
Advertisement
KEY OPERATOR PROGRAMS
Sort Auto Select
If this program is set, the default output mode for copying from an SPF or RSPF is the sort mode. If this
program is cancelled, the default output mode will be the non-sort mode.
q
This program can be used only if an optional dual function board is installed.
To enable sort auto selection, highlight "SORT AUTO SELECT" and press
the OK key to display a check mark in the check box.
To disable this selection, select this program and press the OK key again
to clear the check mark in the check box.
Output Trays
If a job separator tray kit or a finisher is installed along with a dual function board or a facsimile
expansion kit, this program can be used to specify which output tray will be used to receive copies,
prints and faxes.
When "OUTPUT TRAYS" is selected and the OK key is pressed, the following display will appear.
(Example: The following display is shown for a copier equipped with a dual function board, a facsimile
expansion kit, and a job separator tray kit.)
1.
Use the
2.
Press the OK key.
Offset Function
If the offset function is enabled, each set of copies will be stacked offset from the previous set in the
sort and group modes in the centre tray of the copier or in the offset tray of a finisher. This program is
used to enable or disable the offset function for these trays respectively.
When "OFFSET FUNCTION" is selected and the OK key is pressed, the following display will appear.
1.
Use the
centre tray of the copier.
2.
If a finisher is installed, use the
use the
tray of the finisher.
3.
Press the OK key.
130
OUTPUT TRAYS
FAX
COPY
PRINT
PATTERN
and
keys to select the desired pattern of output trays.
OFFSET FUNCTION
CENTRE TRAY
OFFSET TRAY
OFFSET
or
key to enable or disable the offset function for the
or
key to enable or disable the offset function for the offset
1
ON
key to select "OFFSET TRAY" and
Advertisement
Table of Contents
