Setting Up By Manual Search - Medion Remote Control Manual

SETTING UP BY MANUAL SEARCH

If the device does not respond to your remote control, although you tried all
codes from the code list for your device, use the manual code search. With
this function you can find the correct code even if your brand is not listed in
the brand list.
1. Switch on the device you want to operate (TV, VCR, etc.).
2. Press and hold "SETUP" for 3 seconds. The mode LED lights up
continually. (If you press the "SETUP" button only once you activate the
SHIFT- function).
3. Release "SETUP" button.
4. Shortly press the button for the mode you want to operate (TV, VCR, SAT).
5. Press "POWER" repeatedly (it could be necessary to press the button 350
times to get all codes) or "PROG+" or "PLAY" (only VCR) until the device
you want to operate is switched off or working properly. The right code is
found.
6. Press the button "OK" briefly to store the code.
Note: There are approx. 350 different codes pre-programmed for
each piece of equipment. In same cases it can be possible that
only the most useful main functions are available. With some speci-
al devices the described proceeding cannot work out successfully.
The code search starts at the presently stored code number.
5